A Trampoline Enclosure around the
Trampoline helps in providing extra security. The enclosure is made for
safety purpose and not for climbing it or bouncing against it.
Trampoline Enclosures are available in various shapes and sizes so that
they can easily be attached to your Trampoline. It just takes a couple
of hours to fix it and then your Trampoline Enclosure is ready.
Trampoline Enclosure helps to ensure the
security of children if there are many people using the Trampoline at
the same time. Even though the process of putting it together is quite
straightforward, the process for assembling the Trampoline pads must be followed thoroughly.
The Trampoline Enclosure should be
attached to the Trampoline at its feet. The bottom of the pole should
be a foot and a half under the frame of the Trampoline. As each
Trampoline is different, it would be advised to read the respective
manual for the instructions of putting it together. Mostly the poles of
the enclosure get easily fixed to the legs of the Trampoline with
galvanised and stainless U-shaped bolts, nuts and washers.
You need to use ladders to get them
attached to the top of the poles which has already been attached to the
legs of the Trampoline. Many poles come in two halves, though few are
still made as single-pole units. So, if your pole is divided into two
halves you need to allign the holes of each half and tighten the screws
with the help of your screw driver.
The foam sleeves have to be pulled over
the poles. They have to be extended upto the top of the frame of the
Trampoline. Along with the Trampoline enclosures comes a set of caps that have to be fixed at the top of the poles. These are put into use for holding the encompassing net.
One of the ends of the enclosure nets
has to be tied to the top of one of the pole and then stretched over to
tie to the top of the pole beside it. You have to keep repeating this
process unless and until tied all the ends of the net to the poles of
the Trampoline hence making it completely enclosed. Once you are done
with this, the net is suspended over the Trampoline. It should be
pulled down and clamped to the top of the frame. This completes the
process of a Trampoline Enclosure.
Article Source: http://www.compensationsecrets.co.uk/